Thank you - I'd looked at the help page, but I couldn't see the answer there.

Time to upgrade then - thank you!

I have a site with three RBwAPG-5HacT2HnD (mipsbe) managed by CAPsMAN on a RB4011iGS+ (arm). I've just added a new C53UiG+5HPaxD2HPaxD , but it doesn't want to show up on the RB4011. Since I have a spare 4011, I installed the wifiwave2 package on it, and the new access point will very happily connec...

I've fixed it. I have two PPPoE sessions and therefore two routes to 0.0.0.0/0. If I take one interface down, the problem goes away.

Since upgrading to version 7, one of the two issues I've had is with the IP > Routes page. The default route never appears in the web interface - it's there and working - and I get a Javascript error in my browser. Using Winbox, these errors don't occur, so my thoughts are this is a problem specific...

Most probably you're unlucky. And very likely you can revive your device by netinstall-ing it. You're quite right - I booted from another partition, wiped the first and it's all working with the same RouterOS version. Is there any way to dump the contents of the configuration file should this happe...

I have a RB4011iGS+ which I've wiped and upgraded to RouterOS 7.1.1. It was working perfectly yesterday until I rebooted it in error via the UI, and now it refuses to load the kernel image - see below. Bootloader is v7.1.1. I have a separate, identical unit which is running fine. Is this likely to b...

Serious problems here upgrading a 2011UiAS from the final -rc: it failed to load the new kernel image and went in to Ether Boot mode almost straight away. I NetInstall'd 6.43 on to it, rebooted and all was fine until I power-cycled, at which time we were back to the same problem as before. The only ...