Community discussions

MikroTik App
just joined
Topic Author
Posts: 3
Joined: Sat Jun 01, 2019 10:34 am
Location: Bangkok, Thailand

LtAP LTE6 external antenna mounting points

Fri Nov 04, 2022 5:54 am

I have been running some experiments with an external mANT50 connected to my LtAP LTE6, using the ACSMAUFL pigtails and leaving the case open while running it. To make this all a little bit more manageable (LMR400 cables are frighteningly sturdy, and could easily yank the pigtails off the modem), I'd like to install those pigtails and close up the case. I've had a look at the manual at < ... kit-series> but have some remaining questions.

In the Mounting section, there is an image that points out 4 locations where the sockets could be mounted. But it does not refer to the punch-through holes in the main connector panel of the device. I spot 3 location on there, 1 on the left near the reset button and 2 on the right near the GPS antenna socket.

What I would like to do is use the 1 on the left and 1 on the right, as the 2 next to one another seem too close for the chunky connectors.

Any reasons this is a bad idea?
Member Candidate
Member Candidate
Posts: 188
Joined: Mon Dec 28, 2020 12:30 pm
Location: Earth

Re: LtAP LTE6 external antenna mounting points

Thu Nov 10, 2022 4:09 pm

Basically you can mount the antennas wherever you need them or want them. I just bored out holes in the front end of the case for mine.
User avatar
Forum Veteran
Forum Veteran
Posts: 883
Joined: Sun Jun 28, 2015 7:36 pm

Re: LtAP LTE6 external antenna mounting points

Sun Nov 13, 2022 5:46 pm

Check my signature for LtAP pole mounting and here share with you mANT5o pole mounted.

For connectors position you need to use that you can depending of internal length of pigtails that you will use (U.FL to SMA or RP-SMA).

You do not have the required permissions to view the files attached to this post.

Who is online

Users browsing this forum: Amazon [Bot], llag and 7 guests