Apologies for the necro, but I'm putting this here in case someone encounters the same problem
I had to reset both of mine due to a plethora of reasons. However I was too dumb to backup the password before hand so I went looking for the label but it was ripped off due to our harsh and dry weather. The box was also no where to be found as I got this unit years ago.
Anyhow, after much thought I decided to reset my local unit to factory WITHOUT
the default config.. So hold the reset button for 10 seconds or until the USR LED freezes. Afterwards I created a new account in
. Make sure to give it full permissions and a memorable password. Then I went to
System -> Reset Configuration
and reset the unit WITH "Keep users" CHECKED
. Afterwards the unit reset to its default config but the account we created is still there!
After logging in with the previous created password I was able to extract the password. The login password is the same one that's used in the w60g interface. You can then use that password to login to the remote device and configure it as you wish!